Production runs and repeat orders
Production Runs and Repeat Orders for Mesa
Reorder cut plates, formed brackets and mixed component sets for Mesa equipment from the revision specified on each release.
Made in Phoenix, Arizona. Shipped anywhere in the US.
How it works
Same three steps whether it is your first order or your tenth.
- Step 1
You send drawings
A drawing, DXF or DWG with the material, thickness, quantity and the date you need parts. No drawing? A sample or a sketch with measurements is fine.
- Step 2
We quote the quantity
We price the part at the quantity you ask for. Ask about two quantities and you can compare a small batch with a larger one, and tell us what you expect to need later.
- Step 3
We make and ship
Parts are cut, formed and welded in Phoenix, then shipped to you. If a drawing changes, tell us before the run and it is quoted from the new revision; if a date moves, tell us and we say what is achievable.
You may have walked past our work
A few projects from our portfolio:
- Phoenix Children's Hospital
- Valleywise Behavioral Health Center
- Renegade Clubhouse, Cave Creek
- Arizona State University campus
- Apostolic Church
- Moon Tower
Powder coating and finishing are coordinated with our finishing partner, Cardinal. See the projects.
Replenish Defined Parts, Not Just Welded Assemblies
An equipment replenishment order can include flat plates, bent brackets and welded parts in different quantities. List the part number, revision and quantity for each item, rather than assuming every item from the earlier equipment build is needed again. This is broader than the existing Mesa production-welding page.
Cut plates
Flat parts cut from sheet, with slots, holes and rounded corners.
Frames and racks
Steel frames cut, welded and squared up as a matching set.
Brackets
Laser-cut arms welded to a box-section base, made as a set.
Bollards
Steel bollards cut and welded to match each other.
Who sends us repeat work
For a replacement that has changed since the previous batch, identify the superseded revision and send the replacement drawing before requesting a price. Give the quantity needed now and any later requirement separately; a forecast is not an agreed stockholding arrangement or a reserved production slot.
Manufacturers and OEMs
Brackets, plate parts and sub-assemblies you need again as you keep building.
Factories and plants
Replacement parts for equipment, needed again when stock runs low.
Construction companies
The same connection parts and supports, repeated across phases of a job.
Other fabrication shops
Overflow or second-source work, quoted to your drawings.
Questions people ask
Send the prior order reference if available, the drawing revision and quantity for each part, any material or finish changes and the required date. Parts are made in Phoenix and delivery to Mesa is agreed per release.
No. Fabrication takes place at the Phoenix, Arizona shop. Mesa is a service area; delivery, handling and the achievable date are reviewed for each order.
Yes. Tell us what you expect to need later when you ask for the quote. We check it against how much work the shop can take on.
Yes. One drawing can be quoted at more than one quantity, so you can compare a small batch with a bigger one. Price depends on material, setup and the amount of work.
Quote Your Mesa Components
Send the prior order reference if available, the drawing revision and quantity for each part, any material or finish changes and the required date. Parts are made in Phoenix and delivery to Mesa is agreed per release.
Made at the Phoenix, Arizona shop for Mesa. Delivery is reviewed for each order.